CTX PL9 DRIVER

Find More Posts by richpri. It isn’t melted nor did the monitor smoke. Do you think it was serviced previously? Bought a couple just in case. Ask a Question Usually answered in minutes!

Uploader: Vudor
Date Added: 25 February 2004
File Size: 68.99 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63056
Price: Free* [*Free Regsitration Required]

To start viewing messages, select the forum that you want to visit from the selection below. What sort of resistance should I be getting between theFBT pll9 Some similar monitors have a fixed voltage on the flyback drive.

Brother has same monitor without any problems, You can see a clear difference. If you need to reset your password, click here.

Monitor questions before buy…

Check it with a meter with power removed from the Monitor. Yeah, there is a FET feeding it.

This pl contains many real life examples derived from the author’s experience as a Linux system and network administrator, trainer and consultant.

Recent Drivers  HAMMERFALL ASIO DRIVER DOWNLOAD

Do you think it was serviced previously? If they gothey short out, so if it reads infinity on the DMM its likely ok. Find More Posts by redjokerx.

They hope these examples will help you to get a better understanding of the Linux system and that you feel encouraged to try out things on your own. Voltage is high on all pins.

CTX PL9 Blowing HOT

Now the HOT is fused again and R is open. Your flyback is likely ok. BB code is On.

Question about PL7 Black 17 in. Results 1 to 5 of 5. If its not shortedprobably ok. Found fusible 10 Ohm 1 watt resistor R open and replaced.

CTX PL9 19″, looks blurry?

Ask a Question Ct answered in minutes! You rarely see a shorted or open winding on a FBT. Check the solder on all the timing caps too. It might be worth a try to see if it is actually the monitor at fault and not interference or anything else, although it sounds like it is the monitor to me.

Recent Drivers  LINKSYS PCMLM56 XP DRIVER DOWNLOAD

I think you can also run xf86config or xorgconfig and follow the instructions and it will write the config file for you. I replaced the HOT and it shorted again immediately. The screen has the. Found some info on the net about testing FETs, wish I had better equipment. The time now is Thats your whole problem I bet.

ctx monitor problems Questions & Answers (with Pictures) – Fixya

Last edited by richpri; at Not finding what you are cctx for? Mine is connected to GF2 pro. Are you new to LinuxQuestions. You are currently viewing LQ as a guest.

Author: admin